![]() The error code I get is 0d and that occur when a memory stick is plugged in slot A1 or A2.Īt least I can get the sucker up and running now I have found that the computer starts and I get to the BIOS screen just fine and it stays stable with no issue if I use the memory stick in slot B1 or B2 and it also works if I have both memory sticks plugged in to slot B1 and B2 at the same time. I actually using the orignal bracket on the board but a custom spring holder that gives centered load on the water block. ![]() hit bios reset and try less aggressive settings.īe back on tomorrow or someone else maybe able to help you out in the meantime. it very late / early morning here)Ĩd when your overclocking means oops went to far and training of ram / cpu initialization failed. Can be hard to trouble shoot this one as there is noramly three hardware causes and the stuff covered above (unless missed something. Hardware wise typically RAM, the CPU itself, or DOA board. PS An 8d issue at this stage can be caused from stuff above. If none of this helps, then post back and will post some other ideas. Single you could also try 1 or 3 but this second channels. (check it is seated properly as well) You could also try 1 stick only in slot 2 or 4 and than the other as a single to see if either have an is the issue. ![]() The ram needs to be in slots 2 & 4 from the CPU. Also check it's properly plugged in up there. If you have custom bracket did you put it on correctly (some custom backing plates have protective tape that should face the board or otherwise can be installed backwards) or if possible did you over tighten the screws as either can cause this error.ĭid you connect the ATX Power top left of the board (above cpu) must have 8 pin for that chip but I would have both hooked up if you can.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |